Accessories

Mounting Adapter

1. When using the Tundra Tracker

• Removing the tracker base plate

Remove the two screws that secure the base plate. Be careful not to lose the screws during removal.

• Attaching the adapter

Take the mounting adapter for the Tundra Tracker from the case, and secure it to the tracker using the screws you just removed. Make sure the adapter is oriented the same way as shown in the above image.

2. When using the Vive Tracker

• Attaching the adapter

Take the mounting adapter for the Vive Tracker from the case, and secure it using the included screws as shown in the image above.

TIP

By using the adapter designed specifically for the Tundra Tracker, the tracker becomes lower and less prone to wobbling. If you frequently use the tracker for purposes other than with the ContactGlove2, attaching the Vive Tracker adapter to the Tundra Tracker will make it easier to remove the adapter. (Note: The height of the tracker will be higher compared to using the dedicated adapter.)

Mounting the Tracker to the ContactGlove2

Slide the tracker along the rail on the device until you hear a "click" and secure it.

This completes the hardware setup!